Ysi Pro30 User Manual

USER MANUALEnglishPro30

1213RESETTING THE SYSTEM SETUP MENU TO FACTORY DEFAULTTo reset the Pro30 settings to factory default, press the down arrow key while in the System Set

1415Figure 7, solution above two holes near cable. Turn the instrument on and allow the conductivity and temperature 2. readings to stabiliz

1617SAVING DATAFrom the Run screen, use the up or down arrow keys to highlight the Save box and press enter to save the current readings. The instrume

1819Figure 10, Erase data mode. Use the up or down arrow key to select Erase Data Set, Erase All Sets or the ESC-Exit function box, then press enter t

2021SENSOR STORAGESHORT AND LONG TERM STORAGEFor both short and long term storage, the conductivity sensor should be stored clean and dry.Remove the b

2223SPECIFICATIONSThese specifications represent typical performance and are subject to change without notice. For the latest product

2425DECLARATION OF CONFORMITYThe undersigned hereby declares on behalf of the named manufacturer under our sole responsibility that the listed product

26CONTACT INFORMATIONORDERING AND TECHNICAL SUPPORTTelephone: 800 897 4151 (USA) +1 937 767 7241 (Globally) Monday through Friday, 8:

Item #606082Rev ADrawing # A606082July 2011©2011 YSI Incorporated.The YSI logo is a registered trademarks of YSI Incorporated. CONTENTSWarranty ...

iTaking Measurements ... 15Saving and Viewing Data ...

ii1THIS PAGE LEFT INTENTIONALLY BLANKINTRODUCTIONThank you for purchasing the YSI Pro30, an instrument from the YSI Professional Series product fami

23Place the battery cover on the back of the instrument and tighten the 5. four screws. Do not over-tighten.Figure 1. Pro30 with battery cover remove

45Figure 3, Note the keyed connector. RUN SCREENPress the power/backlight key to turn the instrument on. The instrument will run through a self

67appropriate language then press enter to confirm (figure 5). If an incorrect language is selected, it may be changed in the System Setup

89CONDUCTIVITY UNITS (COND. UNITS)Highlight Cond. Units (Conductivity Units) and press enter to open a submenu that allows you to select the conductiv

1011SPECIFIC CONDUCTANCE REFERENCE TEMPERATURE (SPC REF. TEMP.)SPC Ref. Temp. (Specific Conductance Reference Temperature) is the reference temperatur